Workshop «Shaft alignment and dynamic balancing»
We invite technical specialists to participate in the training course on the topic «Shaft alignment and dynamic balancing» which will take place on 06-07 December, 2018 in Germany (Lubeck). The workshop is arranged for specialists in quality, service engineers, mechanics and power engineers who are responsible for the reliability of machines and industrial equipment.

BALTECH GmbH
Kronsforder Allee 45,
23560 Lübeck
Germany
Tel: +49 (0) 451-370-87-700
E-Mail: info@baltech.biz
 
MainProductsDisposalTrainingArticlesContactsImpressum
Products -- Alignment -- BALTECH SA-4000


BALTECH SA-4000

  • Alignment pumps, BALTECH SA-4000
  • BALTECH SA-4000, centering, Reverse dial indicator method
  • BALTECH SA-4000, shaft alignment (Rim and Face indicator method)
  • BALTECH SA-4000

BALTECH SA-4000 is a tool kit for shaft alignment with dial indicators and without a unit for misalignment calculation. This is the inexpensive kit for horizontal and vertical shaft alignment. This tool kit doesn't include a measurement unit and is recommended for use by experienced specialists. The measurements are conducted with dial indicators. The received data is used to calculate the misalignment amount. If you want to extend your system up to BALTECH SA-4100, BALTECH SA-4200 or BALTECH SA-4300 you only need to purchase a measurement unit. The universal fixtures and rods are mounted on the shafts without clearances. To ensure proper alignment we recommend to use stainless steel shims BALTECH-23458N.

  • Horizontal shaft alignment;
  • Vertical shaft alignment;
  • Check and elimination of soft foot during alignment;
  • Alignment method selection: radiaxial method or dial indicator method
Technical characteristics
Number of indicators (dial) 2
Sensor type Dial indicator
Measurement range Not less than 10 mm
Measurement accuracy 0,01 mm
Maximum diameter of mating shafts (couplings):
- with chains
600
- with magnets (options) Not limited
Rod length 320 mm

Back      Main