Workshop «Shaft alignment and dynamic balancing»
We invite technical specialists to participate in the training course on the topic «Shaft alignment and dynamic balancing» which will take place on 12-13 September, 2019 in Germany (Lubeck). The workshop is arranged for specialists in quality, service engineers, mechanics and power engineers who are responsible for the reliability of machines and industrial equipment.

BALTECH GmbH
Kronsforder Allee 45,
23560 Lübeck
Germany
Tel: +49 (0) 451-370-87-700
E-Mail: info@baltech.biz
 
MainProductsDisposalTrainingArticlesContactsImpressum
Products -- Tool kit -- Induction heaters -- BALTECH HI-1660


BALTECH HI-1660

  • A tool for installing couplings, rings, tubes, bearings, BALTECH HI-1660, reliabilitz technologies
  • Heater induction for bearings, mounting of bearings, BALTECH HI-1660, BALTECH GmbH
  • BALTECH HI-1660, bearing installation, induction heater, tools for bearing mounting
  • Bearing installation, induction heating, BALTECH HI-1660, BALTECH GmbH

BALTECH HI-1660 is the industrial professional induction heater intended to heat parts before their installation (for example, bearing replacement, coupling installation, heating of gearwheels before gearbox assembling).

The main elements of the induction heater are: the induction heater on a trolley, control unit, temperature sensor, set of replaceable yokes. The induction heater enables to perform fast, easy and cost effective heating of any parts before their installation. The installed part is a secondary winding, which is heated due to magnetic induction. Bearing heating, coupling heating and installation, gearbox assembling are performed several times faster in comparison with traditional methods (hot plates, oil bath, burners, etc). BALTECH HI-1660 allows to heat parts weighing up to 350 kg with an inner diameter up to 860 mm. For example, the induction heater can be used for electric motor repair. First, the motor housing is heated, after which a stator is installed. Then bearings are installed on a shaft. If you need to heat a part over 240°C, the contact temperature sensor is not installed on the part and the heating temperature is controlled by the non-contact laser thermometerBALTECH TL-0215C. The yoke is moved on the guides and is easily input to the part hole. The induction heater BALTECH HI-1660 has the electronic timer from 0 to 99 minutes. The maximum power is 10 kVA.

Modern electronic base, automatic protection from overheating and automatic demagnetization function.

The functions of the BALTECH HI induction heater: magnetic induction, digital display, sound signal, error report, heating temperature information storage, heating time control on the display, automatic demagnetization and automatic protection from overheating.

Technical characteristics
Model BALTECH HI-1660
Electrics
Nominal power , kVA 10
Voltage , V/Current,А 380/25
Frequency, Hz 50
Rotatable yoke Yes
Heated part
Maximum bearing weight, kg 350
Minimum inner diameter d, mm 45
Maximum outer diameter D, mm 860
W, mm 305
H, mm 209
Yoke dimensions
Yoke width, mm 45;60;75;85;110
Yoke length, mm 450
Control panel
Temperature setting, °С
Maximum temperature, °С
240
Automatic power reduction Yes
Dimensions
Dimensions, mm 940х450х950
Heater weight (without yoke), kg 185

Back      Main