Workshop «Shaft alignment and dynamic balancing»
We invite technical specialists to participate in the training course on the topic «Shaft alignment and dynamic balancing» which will take place on 12-13 September, 2019 in Germany (Lubeck). The workshop is arranged for specialists in quality, service engineers, mechanics and power engineers who are responsible for the reliability of machines and industrial equipment.

BALTECH GmbH
Kronsforder Allee 45,
23560 Lübeck
Germany
Tel: +49 (0) 451-370-87-700
E-Mail: info@baltech.biz
 
MainProductsDisposalTrainingArticlesContactsImpressum
Articles -- Tool kit


Correct mounting of the rolling element bearings

Reliability and longevity of the equipment directly depends on quality of the bearing installation on a shaft. The bearing installation according to the IORS standard should be conducted with observance of certain techniques and is divided into three methods: the installation using the induction heaters BALTECH HI Series, depending on the required capacity and size of the bearings, the heat is uniformly distributed on the surface; mechanical mounting using a special mounting tool kit that uniformly transmits force to the bearing rings without damaging the rings and rolling element; hydraulic mounting using the hydraulic equipment.

Use of open fire is unaccebtable. Instead, use the induction heaters BALTECH HI Series. It should be also noted that change from using the oil bath to use of the induction heaters for heating the bearings has a lot of advantages: precise and uniform heating of the bearing to the defined temperature, minimum heating time, stuff safety, no smell and smoke, energy saving and environmental friendliness.

The proper mounting equipment provides failure-free operation of your facilities and prevents losses caused by emergency shut-downs of machines.